Return pump feed mode.

[Blue80]

I have a few questions regarding my varios 8 return pump and 0-10v wave engine controller.

1. How do I get it to remain on, but run slower in feed mode? Or can I only do simple on/off with this pump?

2.Where can I find the proper voltage speed for these pumps to set it up in the wave engine? Or do I just leave it as the full 0-10v.

Thank you

 

[Danny]

I think you have to setup a schedule and make it active in feed mode and the other schedules inactive in feed mode. HYDROS WaveEngine - How to Create a Feeding Preset - Help Page

 

[Blue80]

Thank you