Dawagner
New member
Hey all,
I am using a triple Water sensor to monitor the level in my Display tank. I am trying to figure out if there is a way to trigger an output when the sensor reads Overflow.
So far all I can find is in the sensor input itself I can have it send an alert if it senses Overflow. But in any other output it looks like the only trigger I can use is if it's dry (or wet if I invert it in the combiner). But I was looking for a way to trigger other outputs when it goes to Overflow. I done even see it available as a "Depends on" selection in an input.
Let me know if I'm missing something! Thank you!
I am using a triple Water sensor to monitor the level in my Display tank. I am trying to figure out if there is a way to trigger an output when the sensor reads Overflow.
So far all I can find is in the sensor input itself I can have it send an alert if it senses Overflow. But in any other output it looks like the only trigger I can use is if it's dry (or wet if I invert it in the combiner). But I was looking for a way to trigger other outputs when it goes to Overflow. I done even see it available as a "Depends on" selection in an input.
Let me know if I'm missing something! Thank you!