Wave engine connect to Tunze

[Brianxcheng]

Hi everyone

This is Brian I’m newbie to Hydros
Currently I m running 120G reef tank

Recently I just into hydros system X4 n WaveEngine.

on my Tunze nano-stream 6055 n 6040
I can use the 0-10V plus adopter to connect WaveEngine in between the Tunze controller.

I just wondering is it have any DIY or something
I can use another Tunze wave maker like 6045?

Or only way I should go for to get something “ Octo pulse (pump only) thank

​

 

[Carlos]

If you already have the Tunze, connect them to the X4 or WE via the 0-10V output. Here are the instructions:

HYDROS Control - How to connect flow pump using 0-10V

This shows you how to connect a 0-10V flow pump to your HYDROS Control and create incredible flow within your aquarium.

www.coralvuehydros.com

If you do not have the Tunze, then the OPs would be a good option. The benefit of running the OPs is the WaveEngine can power AND control the pumps. With the Tunze, the HYDROS can control the pumps but cannot power them. You must use the Tunze power supply and Tunze controller.