Just want to make sure im doing this right. Can i connect my x2 to my x3 via command bus cable with power. I have an XP8 already connected and im going to connect my X3 to it and i also have an X2 that i just recently purchased. Thanks
x3 connect to x2
- Thread starter Billy71
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)
- Admin
- #2
Did you get this figured out or do you still need some help?
2plus2
Member
This thread answers all your questions.
But in short, what your describing is safe.
If you want redundancy you can use a data only from the X2 to the X3, since the X3 is getting power from the XP8 and supply the X2 with it's own power.
forum.coralvuehydros.com
But in short, what your describing is safe.
If you want redundancy you can use a data only from the X2 to the X3, since the X3 is getting power from the XP8 and supply the X2 with it's own power.
Advanced Command Bus
Here is some advanced information on how to setup a more complex step of multiple Hydros devices using the Hydros Command Bus. NOTE: THIS INFORMATION IS SUBJECT TO CHANGE. Coralvue releases new updates that may change how things look, act, or behave. So do note that when reviewing this...
forum.coralvuehydros.com