x4 and xp8 power and command bus

[OSUTeege]

i am getting confused with the command bus and terminator recommendations on the getting started page. i have power to x4 and command bus connecting the x4 and xp8 and then a terminator on xp8. is this the proper wiring? the collective 101 page states 2 terminators are preferred, maybe that doesn't apply to xp8 in the collective?

is this ok?

 

[markk96]

Remove the power to the x4 the xp8 will power it.

 

[Danny]

Do not use a power supply that connects directly to the buss with a XP8 or Wave Engine connected unless you use a data only cable between the controller the power supply is connected and the XP8 or Wave engine. The XP8 and Wave Engine can be connected together on the same buss without an issue.