Thinking of using an LED driver like this one:
https://www.amazon.com/mirrea-100V-227V-Transformer-Compatible-Potentiometer/dp/B0B3JDQ1XD/ref=sr_1_3?crid=13F7Q16Q74Z6I&keywords=led+24v+0-10v+dimmable+driver&qid=1666644615&sprefix=led+24v+0-10v+dimmable+driver%2Caps%2C245&sr=8-3
Input: AC...
Update: I received the 0-10v soil moisture sensor today and have it hooked up to the hydros.
0-10v = 0% to 100% soil moisture level; currently reading at ~20% and cheap backup moisture sensor reading as ~4 (high moisture) - (which seems reasonable; soil is very wet to the touch).
Andrew
Has anyone thought of using the Hydros Universe to power/control a small greenhouse cabinet? I know this has been done before using Arduino/Raspberry-Pi, but I am already in the Hydros universe and love the software interface. I know this is likely the more expensive method and I am utilizing...
I want to use the 0-10v output to control dimming of LED strips... Would it work to use something like this?
https://www.diodeled.com/commercial-grade-0-10v-dimmable-drivers.html
Thanks!
Andrew
I am trying to configure AWC on my freshwater tank. However unlike with a saltwater tank, my fill source is the same - I'm using a RODI system with a solenoid.
My question - how do I have both the ATO Output and Fill Output as the same device?
I have 2 control x4s, which work great independently. They are connected by powered command bus cable with terminator at the end. I created a collective with the primary x4, and a collective is ok with only that x4, but I add the 2nd x4, following the directions on the getting started page, and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.