Search results

  1. K

    Water Change Mode

    Tested and all seemed to work. I will just have to move my ATO Sensor before I start a water change to prevent that alarm from triggering.
  2. K

    Water Change Mode

    So I lowered my Temp Sensor to 70.5, fairly certain my temp did not drop below this when I did my water change. Below is a pic of the settings for the Generic Output. Does this look correct? I did shut off the Run Past Max On Time
  3. K

    Water Change Mode

    If I set up one generic output, say for low, and use the temp probe as input (turn off in water change mode) would it override the low temp alert for the temp probe that I have set up for my two heater outputs?
  4. K

    Hydros Control DC Micro Pump

    I had to zip tie the vinyl tubing to my DC Micro as well. The tubing would eventually get pushed out by flow when my ATO turned on, would be helpful if pump came with connection adapters.
  5. K

    Water Change Mode

    I want to set up water change mode so that the Temp Sensor and the Water Level Sensor for my ATO do not alert when I chose this mode. I can't seem to figure out where I can have these sensors "turn off" when I run this mode. Thanks
  6. K

    Feeding Mode Ques

    I set the Min time to zero. I figured the 5 mins was included in the 15 minutes of Off time for feeding mode. I have also noticed that the Countdown timer for Feeding Mode locks up (stops counting down). If you close the App and reopen the timer starts back up where it should but after a couple...
  7. K

    Controller 4 issue

    i ended up removing old RK Sensor and slowly raised temp to Hydros readings.
  8. K

    Feeding Mode Ques

    I need help with Advanced Settings for my skimmer in feed mode. My skimmer is the only Output that is programmed to turn off in Feeding Mode (15 minutes). However at the end of 15 minutes the Protein Skimmer does not turn back on. Below is a pic of Advanced Settings:
  9. K

    Controller 4 issue

    Thank you for all the help, Factory Reset worked. I probably did not hold the magnet long enough yesterday, it took nearly 2 minutes before the light cycle of death stopped. There were no backups/archived since it was my initial setup. I do have one more question - How are people finding the...
  10. K

    Controller 4 issue

    I did try that. I waited 3 or 4 complete cycles of what I wrote above. Should I go longer?
  11. K

    Controller 4 issue

    I received my Hydros Controller 4 today and began the set up process. Things went well to start, anything that directly plugged in was easy to set up but when I tried to connect to the power strip and single plug I ran in to some difficulty. Was finally able to get these to appear in the app...
Back
Top