Search results

Have you submitted a support ticket?? If not you can always reach us at CoralVue Support Portal and submit one . Or you can send us a support email support@coralvue.com

Are you using the Hydros Wave Engine?? Are you using the IceCap Dual pump controller??

Here is the section all about MODES. :) HYDROS Control Modes - How to Create and Configure a Mode

Not to jump in here , but if you're thinking of extending your WIFI ... please check this out. We have some awesome recommendations that will be sure to help! https://www.coralvuehydros.com/product-support/hydros-control/wifi-constantly-dropping/

https://www.coralvuehydros.com/product-support/hydros-control/

I'm trying to find out for you. Typically folks use just 2 batteries. I'm not sure if this can be done or not, but we are gonna find out . :) Here are the "Standard Directions" https://www.coralvue.com/amfile/file/download/file/128/product/3979/

To me it appears you have a collective of one setup " CDS Reef" if you want to add devices to that collective then you need to follow these directions next. HYDROS WaveEngine - Adding to Collective

After you've done that .. here are the directions for building a collective. Please read all of it before you start https://www.coralvuehydros.com/product-support/hydros-control/hydros-collective-101/

Absolutely. You want to make sure the WE is connected to your WIFI and you can get a status screen on the WE before starting the Collective process.

This Pertains specifically to Eero mesh Routers. We suggest you do this before you attempt to connect your Hydros Device or WiFi power strips. TIP: It has come to our attention that this specific brand of Router can be difficult to deal with when trying to connect your Control devices. Below...

I would say this is outside the norm, but most likely made possible for 2 reasons. 1. You're dosing Kalk around the clock 2. You're refugium is also counteracting the "Normal" PH drop at night. Simple way to test this theory would be to not run the refugium at night. See what impact it has .

Yes , Its always good to "bookend " them . :)

Yes you'll be fine with that. If you decide to expand in the future then I'd suggest throwing another terminator in for good measure.

Yes it does matter and that's a great question. You want to use the Wave Engine's Power supply.

https://www.coralvuehydros.com/product-support/icecap-dual-pump-controller/

https://www.coralvuehydros.com/product-support/hydros-waveengine

https://www.coralvuehydros.com/product-support/hydros-control/hydros-collective-101/ https://www.coralvuehydros.com/product-support/hydros-control/collective-errors/

It does but it doesn't. Once you have selected which control will be the "Master " for the collective, any subsequent Device added into the Collective will loose any programming you might have already done. It will be blank and will need to be programmed again...

If your handy and not shy about a little DIY... Youtube "apex to jebao harness" There are a few good videos that show how you can basically work around using the box.

That sounds about right. It might take a few minutes for it to show the upgrade has taken place. What happens is after you upgrade a few minutes later you'll see a rainbow pattern on the controller. The controller's do a reboot after an install. Give it a few minutes and go back into the App and...