Search results

To interface a CP90 to Hydros X4, you will need: AQLink A1 - AQLink A1 for Apex Controller for Crossflow Gyre DCS DCT Pump Hydros APX Link Cable - HYDROS WaveEngine APX Link https://www.fish-street.com/video/a1manual.pdf

This post will serve as a summary page for commonly used DC (direct current) reefing equipment that can be used with the Kraken. Note that the information provided here is for reference purposes only. Please post below devices you have used and found to work on Kraken and I will update these...

Can you somehow link that API to a relay or Wi-Fi outlet? Use that to trip hydros.

Once you strip the drive cable extension. Pin 1 should be a black wire and pin 2 a red wire.

Updated with Kraken pinout info!

Been running one for 4 months now, no issues to report. Works well!

Please don't send it back to BRS, reach out to support@coralvue.com and they can resolve any issues directly. @Michael can help you get things working right

It’s possible this will work. It might only drop to 2.5V when unpowered since it has a built in pull up/down. Give it a try and see. Shouldn’t hurt anything.

If you are using a wifi strip for a heater, you really should use hydros as the backup control and plug in a secondary heater controller like an ink-bird into the wifi strip. In this case, the wifi strip only toggles in the case where the inkbird has failed on, and your temp sensor reads a...

You will need a 4 pin GX12 connector. The 2 pin connector is only for drive ports. See the highlighted below for where to connect the float switch, to pins 2 and 4 on a GX12-4

No set date but end of summer has been mentioned but not confirmed

Oh the ice cap adapter is definitely different than the maxspect one

What was your old adapter for? was it the HYDROS Maxspect Gyre XF150/250/280 adapter or HYDROS Maxspect Gyre XF130/230? I think those are different from the HYDROS Maxspect Gyre XF330/350 adapter. I have a 330/350 adapter at home just have to remember to look, i THINK from memory it has the...

@Carlos can you please make this a sticky

So I actually just went thru putting AWC on my gf's IM AIO 40gal tank recently. Unfortunately I ran into an issue with the AWC profile in hydros, you can't use this profile without 3 outputs assigned (ATO, drain, and fill). This is because this profile is really made for salt where you hate to...

Did some testing this week with the new high head pressure ATO pump from Tunze. And from initial testing, it appears that it works with the Hydros Drive Port. You need to adapt it for a drive port but thats not too hard. This is the new pump...

Note that NICREW uses TRRS cables, and really should use an adapter like this: NICREW HYPERREEF 50/100/150 0-10V Control

This goes over how to control a nicrew LED (hyperreef 50/100/150 only) with Hydros 0-10V output from a X4 or a WELE/WE (with a collective). What you need: - 2x of these TRS female to pigtail wires Amazon.com - 1x of these TRRS male to terminal block Amazon.com - 1x Hydros quad 0-10V cable You...

Are you giving the sensor 4-5 mins to settle when measuring? It is very slow to change when going from high to lower levels

Colors may not be standard across lots or products. You must use an ohm meter to pin out correctly.