Search results

I get the concentrate and mix it 4 to 1. Here is a link Alkalinity Testing Machine Concentrated Reagent

When I change reagent it takes about 3 test for any difference to show up in the test.

I was able catch mine in the middle of the test. I did not get the initial drain. The video starts during the inital fill and runs until the actual alkalinity testing starts. It is about 9 minutes. The set of the test is the same as it is in the end of the video until the actual testing is over...

The test last about 30 minutes. All but the first 10 minutes is actual alkalinity test after the initial drain and fills and the pH and salinity readings.

That could have happened during shipping. I have one of the older iV's and it is still going.

The XP8's have to be plugged into the wall for the AC outlets on them to work. If you want to plug the Kraken power supply into an XP8 I would not do that. For one if something were to happen to the XP8 you would also loose power to the Kraken. It Kraken power supply is plugged into another...

You can setup three switch inputs on a single 0-10v input but only one will trigger at a time. That may be a problem depending on what they are for. If push buttons where only one at a time is pressed there would be on issue.With float switches only one would trigger so You would have to make...

You know you can use just one float switch for the ATO full and also use the advanced settings to setup maximum on time, minimum on time, minimum off time and maximum off time. If you set a maximum on time with run past max on time set to off it will only run for that long before shutting off...

I just use regular water from the tap to clean off, blow excess water off and pat dry before each calibration solution and before returning it to where it was.

You cannot use bluetooth as a primary connection. The controller has to have internet access to do any setup changes. It this case I would first do a power down reboot on the router wait a few minutes and if it does not reconnect then do a power down reboot on the controller. Apparently it is...

Sounds like there is an air leak somewhere.

Why are you using a depends on for ATO reservoir. You could use the generic output type for your ATO output and then you can use more than one input for control. That would leave the depends on for the manual output you are turning off. Here is my ATO output. It has 5 inputs that can keep the...

Here is a link to in on the CoralVue Outlet Parts web page HYDROS Sole 4.8x8mm Inside Pharmed Tubing, 4.75in .

I got the replacement tubing for it but I have not had to replace it yet but I have not had it that long yet and use it for an ATO pump.

I think this was answered on the R2R thread. If not let me know.

Do you have the power supply for the Sole plugged into the controller and plugged it to a wall outlet. The pump will not run without power to that power port.

CoralVue will not put a pump on the list as compatible unless the pump manufacturer is ok with them doing that. Then they will add a profile to the wave engine for that specific pump.

It depends on whether there was a change in the actual motor from the previous units of if it was just a change in the controller only.

The pump only is just that it has no control built into it. It is just magnets and coils of wire. The issue is that the controller used has to know how much current, pulse width and frequency to apply to get the pump motor to run the right speed and the right direction. The pump motors are BLDC...

The Kraken has 8 24v DC outputs and 4 12v DC outputs so your device would have to have a 24v Dc or a 12 DC power input to use Kraken power. Also make sure that the demand for the device being powered is within the current limits for the Kraken output you want to use and also the overall limits.