Search results

Not passing midnight like that would be a bug. It should pass midnight. I will add this to our internal bug list.

Check the options page in the app. There are entries there to set an on and off time for the LEDs so they turn off at night.

The input resistance of the 0-10V input on the IceCap dual pump controller is about 14 Kohm. Since that is the case, the current draw from the 9V battery will be less than 1 mA. And that will only be drawn while the button is pressed. The 9V battery will last for years.

If it has a 12V motor it should work fine. It will spin the wrong way if you get the polarity backwards but that is easy to fix. Don

The Exit Delay is specifically related to Mode changes that are triggered from an external source (such as a 0-10V input). Mode Timeout refers to changes that are triggered by manual action from the UI. Suppose you set your Exit Delay to 1 minute and your Mode Timeout to 15 minutes. Now you...

Hi, There are a couple logic issues with what I think you are saying. First, the Temperature Low and High point form a pair for hysteresis. So as long as the temperature is between the low and the high point the output is indeterminate. Lets say you set those points to 77.5 and 77.7, which is...

A fix is being tested currently. Should be available shortly.

Pin 1 - GND Pin 2 - +5V supply (current limited) Pin 3 - Digital I/O - DS18B20 for example Pin 4 - Analog Input

When a new collective is created the previous graphing information no longer applies. A new collective will never have any graphing information. That will start to fill in over the next hour or so as new data is collected for the new system. Did the graphing information start to fill in on the...

The C2 does run somewhat warmer than the C4. This is because it has a different power supply type and also is in a smaller box. So yes, this is normal.

Hi, The notification function for level inputs is planned for the next firmware revision. To trigger on WET use a Generic Output or a Klir Output. Thanks, Don

They are back in stock. Sorry for the delay.

Yes, they are DS18B20 based. In theory you could connect multiple temperature sensors to one port but the software doesn't currently support it. With multiple devices on one port it becomes difficult to determine which sensor is which.

Just to confirm, you can connect as many Wave Engines to a powered command bus as you want. These power supplies are designed to work together. It is only the small power supply that must be by itself.

As long as you don't see the number in red during calibration I wouldn't worry about it.

There is a bug we have occasionally encountered on some phones where the Bluetooth does not discover new devices. It is often helped by doing a force stop on the Hydros app. Occasionally is necessary to restart the phone.

I saw your post about getting the older Beta Plug strips. They are not supposed to be shipping them. You should probably contact Carlos about getting replacements. Don

Actually the mV vs % is correct. In theory a pH probe in a solution of 7.0 pH should produce exactly 0 volts. This displays how many mV (millivolts) the probe is actually producing, which is an error signal. If the pH probe is in good shape, this number will be close to 0 and will display in...

Wow, just noticed this was never replied to. I assume this is no longer an issue?