Search results

This is the X2 controller and it is in the middle of the collective. Once i power cycle everything it shows the correct version. It now also shows the correct data.

So, it happened again tonight. Roughly the same time as yesterday. I disconnected the power cable from the X4 controller yesterday and left only the wave engine power cord connected.

Gotcha. So get rid of the power cable going into the X4. Hopefully that helps the issue. Thank you.

That is exactly what i am doing. If i disconnect that from the wave engine, the gyres stop working.

Ill be honest, i am lost on what you are saying here. I obviously need the power pack for the wave engine. So if i have the we, x2, and x4 how exactly should the collective be wired together and where so i put the terminator. I currently have it X4 wired to the x2, wired to the we. The we has...

I have a power cable in the x4 and a cable going to the x2, than a cable going to the WE with a Terminator and a power cable for the wave makers. Should i remove the power cable from the X4?

See picture. I have 1 link cable and 1 bus terminator.

I had no messages regarding a controller offline. It literally just prompted me collective broken. If the cable was bad, you would think a reboot wouldnt fix it?

I rebooted that controller and that didnt fix it. I had to unplug the power from the collective and that fixed it. I need to figure out why this is happening as i obviously cant unplug the power if im out of town

I am starting to regret this hydros system. Since day 1 i have had bad sensors, bad wifi outlets, numerous error messages, and now for the 2nd day in a row i get collective broken. Yesterday i unplugged everything and did a hard reboot and that fixed the issue. Now today it is doing it again...

Yes, as you can see the fill timed out after 45 minutes but it never filled anything. When i was awake i had to manually set it to on to fill the water back up.

Yes, Chicago time zone

Well, it worked last night fine after i rebooted the collective, now this morning its back to the same issue. Not sure whats going on here, or why its doing this.

Disregard. I rebooted my collective and its back to normal. Not sure why it did that.

So i had my AWC setup and working flawlessly the past few weeks. The last 2 days the pumps show they are on when they are scheduled to in auto mode but they aren't actually on. No voltage or watts being shown. So they just run until they reach the maximum allowed time. I can changed them from...

Ya, i would have no issue wiring that up, but at this point i might as well just buy another controller and add 2 more ports.

Damn. Thank you

Can the hydros dosing pump be powered by one of the usb ports on the wifi power strip. I have no more drive ports or wifi plugs available. I figured i could just splice in a usb plug into the cable.

Im getting a replacement sent out. It always shows dry

That's crazy. Here is a pic of mine showing it completely submerged with the skimmer still running. Just doesnt make any sense to me why its doing this.