JeffB418
HYDROS Expert
The following resource is how to interface the following Jebao pump products to Hydro's 0-10V port on the Wave Engine V1/V2 or X4 controller:
This interface method replaces the standard Jebao controller with a 0-10V compatible controller from Coral Box. The Coral Box AquaLink A1 is a 3rd party driver box that uses your existing Jebao pump and power supply and allows 0-10V interface to Hydros using the 0-10V OUT port on the WEV1 WEV2 or X4.
Items you will need:
- Supported Jebao pump (see above)
- AquaLink A1 (AQLink A1 for Apex Controller for Crossflow Gyre DCS DCT Pump)
- Hydros APX Interface Cable - HYDROS WaveEngine APX Link
- Open 0-10V OUT port on a Hydros X4, WEV1, WEV2 or 2 0-10V out channels (1 RJ45 connector)
1) configure the A1 interface box per instructions: https://www.fish-street.com/video/a1manual.pdf
2) Plug the APX cable into the free 0-10V OUT port on Hydros
3) Plug the RJ45 jack marked channels 1/2 into the A1 interface box
In Hydros you will need to make 2 outputs, one for SPEED and one for DIRECTION. Hydros pump schedules only can control speed using 0-10V so for DIRECTION you will need to make a CONSTANT output for CHANNEL 1 and set it to fixed 0V for forward (10V for reverse).
Then for the pump speed, follow the standard tutorial for configuring the output and schedule noting that the 0-10V output for SPEED is CHANNEL 2:
This interface method replaces the standard Jebao controller with a 0-10V compatible controller from Coral Box. The Coral Box AquaLink A1 is a 3rd party driver box that uses your existing Jebao pump and power supply and allows 0-10V interface to Hydros using the 0-10V OUT port on the WEV1 WEV2 or X4.
Items you will need:
- Supported Jebao pump (see above)
- AquaLink A1 (AQLink A1 for Apex Controller for Crossflow Gyre DCS DCT Pump)
- Hydros APX Interface Cable - HYDROS WaveEngine APX Link
- Open 0-10V OUT port on a Hydros X4, WEV1, WEV2 or 2 0-10V out channels (1 RJ45 connector)
1) configure the A1 interface box per instructions: https://www.fish-street.com/video/a1manual.pdf
2) Plug the APX cable into the free 0-10V OUT port on Hydros
3) Plug the RJ45 jack marked channels 1/2 into the A1 interface box
In Hydros you will need to make 2 outputs, one for SPEED and one for DIRECTION. Hydros pump schedules only can control speed using 0-10V so for DIRECTION you will need to make a CONSTANT output for CHANNEL 1 and set it to fixed 0V for forward (10V for reverse).
Then for the pump speed, follow the standard tutorial for configuring the output and schedule noting that the 0-10V output for SPEED is CHANNEL 2:
HYDROS WaveEngine - How to connect pumps using 0-10V
www.coralvuehydros.com