pH only sample?
- Thread starter OSUTeege
- Start date
- Tagged users None
Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)
Danny
HYDROS Expert
The iV does not take any readings. It is a vessel with a built in stirrer and a place for 2 probes and a place to put tubing from the reagent, fill and drain pumps. The reading are taken by a controller with a pH port and a salinity port f you want to do salinity also in the iV. The main reason for it is alkalinity testing which uses a pH probe and a reagent to determine the alkalinity of the test sample. But in doing that it get a pH reading and salinity reading just before starting the alkalinity test.
I’m following all that. Sorry my question was probably not clear enough. I’m just asking if I can run a ph/salinity only test. I would like to get more ph/salinity readings throughout the day but not have full cycle run for alkalinity and use up excessive amounts of reagent.
Danny
HYDROS Expert
Not at this moment.
Danny
HYDROS Expert
There is a place on the forum where you can make suggestions like this. I have already suggested it but it does not hurt that they know others would like the ability to do this also. Here is a link HYDROS New Features/Equipment Requests