Recent content by JeffB418

Go to your feeder output in hydros, make a small change on the output to force it to show "Upload Changes" and then push that update. Then go back and change that seeing back and upload again. That will fix your issue.

You have to update wifi settings on all devices one at a time. HYDROS Control - Update WiFi Credentials

Coralvue monitors that thread. They have a lot of irons in the fire and other things take priority. New product dev like Maven and lights consume a lot of the current manpower.

https://forum.coralvuehydros.com/forums/hydros-new-features-equipment-requests.26/

Yeah, Im debating on testing out one of these boosters in that same configuration to see if that's still true on models like this https://a.co/d/065drX4X

Video on boosters

Kraken is great for emergencies to keep flow going (number 1 important thing in a power outage situation). Heaters are def more of a generator thing. You can go much longer without heat over flow.

No, the battery port does NOT support anything over like 15V. You can't use dual batteries. However there is a DIY option of using boosters that take in 12V OR 24V and always produce 24V. Just note that using one of these has a ripple effect on current draw when in 12V mode. Basically current...

Hmm that is odd. I have some krakens running well above 8A and im still in the 90s. How do you have yours mounted? Does it have air flow around it?

Other option is to use these 2 together. You’ll need some teflon pipe tape or similar to make sure the seal is good. https://a.co/d/857P4vm https://a.co/d/cugFQH0

I’ve used these together to adapter the blenny hose to my ice cap dosing containers that use push fit 1/4” This push fit into my dosing container. https://a.co/d/esm78Rm Which goes from 1/4” to 3/16” Then use 3/16” ID tubing (use short piece) https://a.co/d/cnsQowz Then finally these barb...

Hydros START is now a cheaper option than the Launch to add 4 outlets. Tho its still around the price of a XP8. Tho you could get rid of that XS with a START as well.

Your DC voltage shows 12V, while it should be 24V if the meanwell power supply is ON. Plus the high negative current on the battery tells me that its pulling just from the battery and not from the meanwell. Check the meanwell supply.

The SD card on the XP8 is in a difficult place to get to, its on the top side of the board under where the command bus port mini-board is. Definitely reach out to support on how to change this out since it will take a few careful steps to access (removing the board from the faceplate, etc).