Search results

It would be nice if the web page app had the same functionality as the phone app, specifically the ability to add new devices.

Many thanks. I appreciate your time and patience. I misinterpreted the pH setting. I thought that with an AND connector, the outlet would trigger when both conditions were "true" so I thought that when the pH was within the 7.5 to 8.4 range, that would be "true" and the outlet would open if...

No. I want it to turn on when the pH is between 7.5 and 8.4 AND the float is dry.

Can anybody tell me why my kalk ato fill output is not working? I want it to come on when pH is between 7.5 and 8.4, AND when the float switch (Hydros optical) shows a low sump level. I can turn it on and off manually, but the auto doesn't work.

Carlos got my web app working again. iPhone app still stuck.

Me too. Suddenly stuck on "Waiting for Config." Reboots of router, collective, forced upload changes, all failed. I can't get a status or do anything.

Thanks. Got it. I also meant to ask if when you have 2 inputs (here pH and float low) the output will activate when BOTH or EITHER is true? I'm assuming both.

Hi, I want to create an output that activates when Ph is above 7.5 AND shuts off when Ph hits 8.4 AND only activates when the float switch is Dry. I'm confused by the option "Active When Input 1" is set to pH low. Does that mean the output activates at the pH low point I specified AND...

Thanks. Just did.

I can't do that because that controller refuses to update, so I can't even get a status page for it.

...and sometimes it doesn't get even that far. On the update page, all devices update except the xp8 which just spins the green circle for update changes.

Sometimes it seems to be successful adding to the collective, but then everything starts flashing red on the screen and it says "collective broken." Sometimes it seems to add the xp8 to the collective but then won't give me a status: gray screen: have to reboot my iPhone and/or reinstall the...

My new xp8 came with firmware 198. My other stuff in the collective is 197. Could this be the reason I'm having a hard time adding the xp8 to the collective? Breaks the collective every time. Cables, terminators properly installed. The collective (x4 and wave engine) and the xp8 both work...

So in general, the on/off depends on switch takes precedence over any minimum/maximum run times? In other words, they don't kick in until the depends on triggers on first, right?

Hope this isn't a dumb question. I can't figure out how to connect my new xp8 to wifi, before I wire it into my collective. Collective instructions say not to add it to the collective unless it's on wifi first. When I try to use the add wifi device procedure, it doesn't give me an option for...

I have 2 questions about how to set up delays. I know how to do them in my former Apex world because there are Delay commands. But... 1. I have a mode/schedule to shut off everything (return pump, skimmer, wave pumps) for SPS target feeding and water changes. Of course, the sump fills up...

For outlets/devices that allow voltage regulation, are there any rules of thumb on how to set minimums and maximums? I'm not proud to say that I'm electrically "challenged."

Thanks Danny. So if I don't use the x4 power supply and use the xp8 and wave engine power supplies (but not the x4 one), I don't need a data cable, right? Given "TIP: The power supply on the XP8 is isolated from the bus ports, and so are the power supplies on the WaveEngine. Therefore, they...

I'm confused about the danger of 2 power supplies in a collective. In the collective instructions, it says "TIP: The power supply on the XP8 is isolated from the bus ports, and so are the power supplies on the WaveEngine. Therefore, they can safely connect with data/power command bus cables...

That worked. Thanks!