Search results

Hello I have the AF4 frozen food feeder for my tank it’s connected to my x4 through the 0-10v cable I have it set to feed 3 times a day in 5 hour intervals what I can’t figure out is I want to control my pumps that are connected to my wave engine to reduce flow but I cant figure out how to...

Hello I have a hydros controller and I have my ato container in my garage as I have no room for it near or under my tank the question I have is it possible to use or configure something to have a pump or preferably a doser pump water to my tank I have the 1/4 inch tubing already ran through my...

Hello I have the hydros X4 & X10 th ph probes are the same and are calibrated with the same calibration fluids I have both probes in my sump as I took down my IV the issue I have is they are reading off by .26 my x4 ph probe reads 8.04and the x10 reads 8.3 I calibrated them both at the same time...

I have them powered up using there power supply I put 0-6.5 as recommended but it’s not working the out put shows that they are running show the percentage of the flow but there is no flow I have them on my pump schedule and still nothing thanks

Hello I have 2 tunze 6105 I am trying to add to my wave engine I have the 0-10 cable as well as the adapter and I hooked up correctly when I add the output but and it shows the percentage the power to the pump there is no flow any suggestions

Mine is doing the same thing can you tell me how you resolved this issue my IV was leaking I don’t know if the fill rate is to fast or what I did follow the video to the tee but water was underneath the beaker thanks