Recent content by John Neuzil

Even more specific than that. It would be nice to set a custom alert time on each individual sensor.

It would be nice if the time between notifications could be set differently depending on the item. Like leak detectors I may want every hour but a low level sensor every day or so.

Ok. This is getting really annoying. A couple of times a day disconnect messages STARTED with the new update. Am I the only one?

All my Hydros wifi devices were solid until this last update. Now I get a disconnect notice a couple of times a day then everything reconnects. I've rebooted all controllers and my router.

That was it. Thanks Danny.

I've made some changes to a tank and don't need multiple devices or a collective any longer. I removed one device so now I only have a one device collective. How go I remove the collective,?

Maybe I misunderstood the issue. The app used to close but that was fixed where it stays open but you do still need to refresh.

I use old phones for Hydros screens and the app stays active

It did happen to me. I had to reinstall the sensor. Turn off alerts, save changes then delete. That worked for me.

Is something turning off and on every 12 hours ?

Thanks, I'll try that

I would like to be able to delay notifications on specific sensors. For instance I have a level sensor in my sump to notify if the level is too high. Trouble is it goes off in feed mode when the pump is off. I would like to disable it for a set time during feed mode.

Could be just my Samsung phone

I have two collectives and one individual controller on my Hydros app. When I switch the view from one collective to another remnants from the previous collectives outputs and pages remain on the screen as if they are part the newly selected collective. I then have to re select the collective...