Search results

Just started the setup of the wave engine le and two icecap 2k gyre pumps. Feeling silly on variable pump selection in setup. Do i pick icecap 2000? I think so but want to be sure.

Would be great if Hydros worked with the new Insight screen

Probably an easy task but is there a video or instructions on how to change the tubing on the Sole pump? I looked but could not find any.

It may be an easy process but is there a video or instructions on how to change out the tubing on the Sole?

What is up with 367 and when did that release?

Can the salinity probe be submerged? I ask because when my main pump is off the level in my pump chamber rises submerging my probe rack. My pH probe is submersible so its ok.

I was thinking maybe I could use a float level sensor to tell me when the roll was getting close to needing change. First attempt here.

While the operation of the Sole pump has been flawless it continually disconnects from wifi. All the other five controllers, two wifi strips and feeder stay connected buy not the Sole. Operation is unaffected so not a big deal but is mine the only one?

I'm using the Sole and like it but trying to learn more about it. Two questions 1. What is the meaning of the mode led when flashing green or solid blue. 2. What does the tab in the app "unkink tubing" for and do. Thanks

I have an X3 in my collective with Four other units. I want to remove the X3 from the collective and use is in a collective on another tank. I deleted the sensors and probe that were attached to it so it is now empty. When I go to delete it from the collective I get a red bar that says "7 is...

Looking for insight on hopefully a quick fix. One of the X2's in my collective refuses to update when something is plugged into sense Port 1. I will take the update on the initial install of the port but even though the port is giving a reading after the initial install the device will not...

It would be nice if the time between notifications could be set differently depending on the item. Like leak detectors I may want every hour but a low level sensor every day or so.

All my Hydros wifi devices were solid until this last update. Now I get a disconnect notice a couple of times a day then everything reconnects. I've rebooted all controllers and my router.

I've made some changes to a tank and don't need multiple devices or a collective any longer. I removed one device so now I only have a one device collective. How go I remove the collective,?

I would like to be able to delay notifications on specific sensors. For instance I have a level sensor in my sump to notify if the level is too high. Trouble is it goes off in feed mode when the pump is off. I would like to disable it for a set time during feed mode.

I have two collectives and one individual controller on my Hydros app. When I switch the view from one collective to another remnants from the previous collectives outputs and pages remain on the screen as if they are part the newly selected collective. I then have to re select the collective...

It would be nice if probe level alerts were automatically disabled when calibrating probes.

Two days ago I deleted and removed my skimmer sensor. I keep getting and alert every few hours that the sensor is in alarm state. I tried rebooting the collective and cleared the cache. Any thing else to try.

Before I proceed farther than I should what is the procedure to clean the flow sensor. How far can it be safety disassembled. Thanks

Probable don't need them to set it up but while I grab a plumbing part I thought I'd check the included getstarted card to read the flow meter instructions but there don't seem to be any. Just thought I'd mention it or maybe I missed it.